Examples or expressways are the New York State Thruway, major interstate routes and parkways.īefore you travel on an expressway, identify your entrance and exit points on a road map. The speed limit is normally 55 mph (88 km/h), but can be posted at 65 mph (105 km/h) in some rural areas. You normally enter or exit the expressway on ramps (controlled-access). "Expressway" means any divided highway where traffic moves in one direction on two or more lanes. If you run "down the track," in the same direction as the train, you can be hit with debris when the train hits your vehicle. If a train is approaching, run toward the train but away from the tracks at a 45-degree angle. Run toward the general direction the train is coming from. Locate the Emergency Notification System sign and call the number provided, telling them about the stalled vehicle. Get away from the tracks, even if you do not see a train.ģ. GET OUT! (That includes EVERYONE in the car, children, babies, an elderly passenger, etc.)Ģ. What should you do if you stall on the tracks, for any reason?ġ. Stay behind the stop line while waiting for a train to pass. Pavement markings will often show you that a grade crossing is ahead. Sometimes, grade crossings do not have flashing red light signals or gates. Remember those rules if you are following one of these vehicles. School buses with or without passengers, other buses with passengers on board and vehicles with explosives or flammable cargo must stop at all railroad crossings. If other traffic prevents you from going fully across, wait and go across only when there is room. You cannot go across any railroad tracks unless there is room for your vehicle on the other side. If an approaching train is near enough or going fast enough to be a danger, you cannot go across the tracks, even if they have no signals or the signals are not working.ĭo not, under any circumstances, attempt to cross any railroad tracks unless you are certain your entire vehicle will clear all of the tracks at the crossing. Look and listen for trains before crossing any railroad tracks. If there are multiple train tracks, the sign will show the number of tracks. Yield when you see a crossbuck sign, which is a sign shaped like an “X” with “RAILROAD CROSSING” printed on it. Do not drive around or under a gate that is moving up or down. Do not go across the tracks until the lights and bell have stopped and the crossing gates are completely up. (See "Railroad Crossing Signals".)įlashing red lights, lowered crossing gates and/or a bell at a railroad crossing indicate that you must stop, at least 15 feet (5 m) from the tracks. Most buses and some trucks must stop at railroad crossings. If you are following a bus or truck approaching a railroad crossing, be careful. MEANING: There is a railroad crossing ahead. Remember that the train you see is closer and faster-moving than you think, and be aware that trains cannot stop quickly.ĬOLOR: Yellow with black letters "RR" and "X" symbol. If there are multiple tracks, wait until you can clearly see down all sets of tracks in both directions for another approaching train before crossing. If you see a train coming, wait until it passes, and then cross the tracks when it is safe to do so. Before you cross, be sure that a train is not coming. When approaching unmarked, or passive, grade crossings, slow down and be prepared to stop. Some grade crossings do not have gates or flashing lights. It is illegal and dangerous to go around lowered gates or to cross while the lights are still flashing. When approaching marked, or active, grade crossings, do not proceed until the gates are completely raised and the lights are off. Some grade crossings have flashing red lights or lowering gates when a train approaches (“active” grade crossings). (You will learn later in the section what to do if your vehicle stalls or gets stuck on a track.) When crossing tracks, always stay in your lane and in the same gear. Never race a train to a crossing, never drive around lowered gates, and do not stop on tracks. Trains can run on any track, at any time, from either direction. As you approach a crossing, always expect a train. To be a good and safe driver, you must learn how to drive on expressways, at night, in bad weather and when an emergency occurs.Ī grade crossing is the point at which train tracks intersect with a roadway and is considered an intersection. When special conditions or hazards occur, attention and judgment become even more important. Note: Practice quizzes are available only for those sections of the manual covering rules of the road (Chapters 4 through 11 and Road Signs).Įven under the best conditions, driving requires your full attention and your best judgment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |